What is Rapid Air Technology?

Rapid Air technology is another name for the RUSH technology that was developed by APDS Development during the development of the Airfryer. RUSH stands for Radiant and UpStream Heating, which tells us something about the way heat is transferred. Distinctive about the technology is that heat is transferred with very high intensity, that heat is distributed over the food from all sides and that the heat can penetrate through a thick pile of food particles.

Rapid Air technology

rapid_air_principleFigure 1 shows a schematic overview of the ‘RUSH principle’. Radiant heat is coming from a heating element just above the food and convection heat is coming from a strong upwards moving air stream that flows through the open bottom of the food chamber. So heat comes from both sides and is totally focused at the food. All air is forced to pass over the food and heater surface by every circulation cycle, there is no idle air circulating around (like in a convection oven). The total air volume to be heated is limited and circulates inside the space where the heat is required. A special air guide profile on the bottom of the preparation room creates a optimized airflow pattern to distribute the air, loaded with heat energy, evenly over the bottom side of the food.

This technology was created to mimic the effect of a deep fryer with air as a heat carrier instead of oil. Because oil can hold and transport much more heat per dm3 than air it takes much more air to transfer the same amount of heat. The rapid airflow inside an Airfryer transports the heat to all parts and sides of the food with high intensity. It can penetrate through a thick pile of food. The radiation from the heater, which is partly in the far infra red range, penetrates deep under the food surface. This combination caused a very high heat transfer rate and can create a cooking result that is comparable with deep frying.

When compared to a convection oven…

  • Preparation times are 25-50% lower
  • Preheating time is 50-75% lower
  • Energy consumption over 24 h can be more then 50% lower

Like a convection oven an Airfryer is a multipurpose tool for food heating. It is suitable for many kinds of food. What you can do with an Airfryer and NOT with a convection oven is:

  • Stack the food inside the food chamber
  • Shake the food during preparation to rearrange the orientation
  • Use it as a deep fryer

Cooking effects

Cooking results depend greatly on the way and speed with which heat is distributed to the food. Although Rapid Air technology is suitable for all kinds of food, the effect on french fries is used to illustrate the differences with a convection oven.

Because the heat intensity is higher, in other words the effectiveness of the heat is better, the crust forming starts earlier and the preparation times are shorter. This results in that more of the original nutritional values and moisture levels are preserved.

Basically all types and size of fries can be prepared in an Airfryer, even home made. Prebaked fries allready have a layer of fat, they don’t need addition oil to finish them. Home made fries require a pretreatment in a bowl to distribute a bit of oil over the food surface.

Cooking with an Airfryer

Cooking with an Airfryer is like deep frying. You put the food in a food basket, but in an Airfryer the sidewalls of the basket are closed, only the bottom is open. This guarantees the all air will pass over the food surface. Just like deep frying you can take out the basket during the cooking cycle to rearrange the ingredients, to avoid that they stick together and to expose other food surfaces to the heat. Off course shaking is only necessary when the food is piled up. When cooking other types of food, like snacks, chicken, fish or to bake off bread for instance, the cooking process does not require any user action.